# HPCS 6500 — Open-Source Driver

Python driver and CLI for the HPCS 6500 spectrophotometer / integrating sphere.

Communicates directly with the instrument over USB serial, replacing the
vendor software for measurement automation and data extraction.

## What This Does

- **Measure**: Luminous flux (lm), CCT (K), CRI (Ra, R1-R15), chromaticity
  (CIE xy, uv, u'v'), radiometric flux, spectrum 380-1050 nm
- **Electrical**: Voltage, current, power, power factor, frequency
- **Harmonics**: 50-harmonic voltage/current analysis, UThd, AThd, waveforms
- **Power supply**: Control the built-in AC (100-240V, 50/60Hz) and DC
  (1-60V, 0-5A) power supply
- **Export**: CSV output for data logging

## Quick Start

```bash
# Install
uv sync

# Single measurement (auto-detects device, turns PSU on/off)
uv run hpcs6500.py

# Continuous measurements
uv run hpcs6500.py --continuous

# Quick test (lumen + CCT only)
uv run hpcs6500.py --quick
uv run hpcs6500.py --quick --continuous

# Show full spectrum + harmonics
uv run hpcs6500.py --spectrum --harmonics

# Save to CSV
uv run hpcs6500.py --continuous --csv output.csv
```

## Power Supply Control

```bash
# Read current PSU settings
uv run hpcs6500.py --psu-status

# Set AC mode, 230V 50Hz
uv run hpcs6500.py --mode ac --voltage 230 --frequency 50

# Set DC mode, 12V with 1A current limit
uv run hpcs6500.py --mode dc --voltage 12 --current 1.0

# Manual PSU on/off
uv run hpcs6500.py --psu-on
uv run hpcs6500.py --psu-off

# Set integration time (ms)
uv run hpcs6500.py --integration 500
```

## Offline Parsing

Parse previously captured USB traffic (pcap files from USBPcap):

```bash
uv run hpcs6500.py --parse captures/some_capture.pcap
uv run hpcs6500.py --parse captures/some_capture.pcap --quick
```

## Files

| File             | Description                                        |
|------------------|----------------------------------------------------|
| `hpcs6500.py`    | Driver class (`HPCS6500`) and CLI                  |
| `usb_capture.py` | USB traffic capture tool (requires USBPcap)        |
| `PROTOCOL.md`    | Complete protocol reference (byte-level)           |
| `pyproject.toml`  | Project metadata and dependencies                 |

## Hardware

- **Device**: HPCS 6500 spectrophotometer / integrating sphere
- **USB**: STM32 Virtual COM Port (VID `0483`, PID `5741`)
- **Protocol**: Custom binary over serial, documented in [PROTOCOL.md](PROTOCOL.md)

## Dependencies

- Python 3.11+
- `pyserial` (serial communication)
- USBPcap (only for `usb_capture.py`, not needed for normal operation)

## Protocol

The binary protocol is fully documented in [PROTOCOL.md](PROTOCOL.md),
including all command bytes, data block layouts, field offsets, and the
complete measurement sequence.  This was reverse-engineered from USB
packet captures of the vendor software.